The
ANBR9 Cellular Repeater is designed to overcome the major problem of
intermittent cell phone reception whilst inside a building. The ANBR9 Cellular
Repeater will amplify and enhance signals on the CDMA/TDMA/AMPS 800 & 3G 850
cellular networks to allow the user to greatly improve their own signal
coverage. The ANBR9 is ideal for medium size areas such as factories, large
offices, large homes and parking lots.
The
ANBR9's Automatic Gain Control (AGC), Manual Gain Control (MGC) and Automatic
Shut Down (ASD) prevents RF radiation and distortion caused by the RF out signal
being higher than the regulated output. The ANBR9's output amplification stage
results in a significant improvement in output power linearity.
Networks: CDMA and 3G (Next Generation 850Mhz Networks)
In Building
Cellular Repeater Kit
Description
The ANBR9
Cellular Repeater will amplify and
enhance signals
on either the GSM, CDMA, or
TDMA analogue
and digital cellular networks.
Designed to
overcome the major problem of
intermittent
cell phone reception whilst inside a
building, this
unit allows the user to greatly improve
their own signal
coverage. Ideal for medium size
areas such as;
factories, large offices, large homes
parking lots
etc.
With AGC
(Automatic Gain Control), MGC (Manual
Gain Control)
and ASD (Automatic Shut Down) the
ANBR9 prevents
RF radiation and distortion caused
by the RF out
signal being higher than the regulated
output. The
ANBR9’s output amplification stage
results in a
significant improvement in output power
linearity.
Features
.
-
+19dBm(~100mW) Linear Output Power
-
High Gain of 70dB
-
Servicing up to 4-6 indoor antennas
Coverage area up to 1000 sq.m2
-
AGC & MGC(Automatic & Manual gain control)
-
ASD(Automatic shut down) function to protect
again excess input level and reset automatically after 10 sec.
-
Very Low power consumption
-
Compact size and light weight
-
Easy installation and cost effective
Manual &
Automatic Gain Control
(MGC & AGC)
DC & RF Status &
Alarm Indicators
New Features!
High Linear
Power & Gain
Automatic Reset
Shut Down
Pass Band Ripple
6 dB
max (p-p)
Noise Figure
6 dB
max
Tx/Rx Isolation
85
dB min
VSWR
<1.5 :1
Interm odulation
<-36
dBm (at +16 dBm/2tone)
ALC Range
17+/-2dB
Shutdown Powe r
Level
+25 dBm min
(Down),+22 dBm min (Up)
Shut down alarm
should be automati call y reset after
10 seconds of
normali zati on of the input power.
Operating Tempe
rature
0º - 50º C
Operating Humidity
+10%
- +85%
Power Requirements
+12V
DC, 1.8A
RF Connector
TNC
female
Weight
1.5 kg
Size
140 (W) × 30
(L) × 42 (H) mm
Down
Up
GSM 900
935 - 960 Mhz
890 - 915 Mhz
Model ANBR9B-900
pecifications
Frequency
Range
Down
+19 dBm /
Total
Up
+16 dBm /
Total
Output Power
(Composite
Power)
Gain Down
+70 +/-
2dB
Up
+70 +/- 2dB
| 
